CarbonX™ CFR Carbon Fiber Reinforced Nylon Filament is a semi-aromatic polyamide copolymer reinforced with high-modulus carbon fiber. This filament is ideal for anyone that desires a structural component with high modulus, improved chemical and thermal resistance, excellent surface quality, and ease of printing. Tired of nylon that warps? This is the answer you've been looking for. Excellent dimensional stability comes from the carbon fiber and the semi-aromatic nylon.
Why is it important that CarbonX™ CFR Nylon is a semi-aromatic polyamide? Semi-aromatic nylons have a large cyclical structure in its backbone which makes them stiffer, more chemically resistant, less moisture sensitive, and have improved dimensional stability vs. aliphatic nylons such as PA6, PA66, and PA12.
- High Modulus Carbon Fiber - excellent stiffness
- Semi-Aromatic Polyamide
- Lower moisture uptake vs. PA6
- Improved chemical resistance vs. PA6
- Less shrinkage / warp vs. PA6
- Low-Gloss Surface
- Excellent Printability
- Includes 1 sheet if GeckoTek
Recommended Print Conditions:
- Extruder: 240-270°C. CarbonX™ CFR Nylon exhibits improved layer bonding at higher temperatures.
- Bed Temp: 80 - 100°C
- Bed Prep: Polyimide Tape, Clean glass with ABS/Acetone Slurry
- Nozzle: 0.4mm or larger. We currently recommend our A2 Hardened Steel Nozzles - HERE
- Layer Height: Ideal layer height is 60% of nozzle diameter. We do not recommend printing layers below 0.2mm with CF Grades.
- Drying - very important. This product is supplied dry and sealed in thick 4mil pouch with several packs of desiccant. However, it is made using nylon and will absorb more moisture than other resins when left exposed to the environment. Excessive moisture will result in popping at the nozzle (water boiling off, a little steam) and excessive drooling and nozzle build-up. Make sure to keep this filament in a dry location between uses. If the filament does get wet, you can dry it out with a basic toaster oven (not one for the family food!). We recommend drying it for 2-3 hours at 70-80°C. Caution: Make sure to check back often to make sure you're not distorting / melting the reel - the reel itself has lower thermal resistance than the nylon filament and will distort / melt before the nylon.
Please contact firstname.lastname@example.org to request shipment from a pre-purchased filament bundle or for any other purchasing requests.